How to Install TruShield HalfShade Top (07-18 Wrangler JK) on your Jeep Wrangler

1. Carefully open the package using a box cutter or knife (Figure A) and ensure the top and bungees are included and undamaged.

2. Lay the HalfShade out flat (Figure B). 

3. Remove the hard top or soft top from the vehicle. 

4. Place the HalfShade over the top of the vehicle (Figure C). 

5. Run a bungee through the hole at the front of the HalfShade on the driver's side (Figure D). 

6. Run the bungee around the front driver's side sport bar (Figure E). 

7. Repeat Steps 5 and 6 on the passenger's side sport bar (Figure F). 

8. Repeat Steps 5-7 further down each side, going from driver's side to passenger's side (Figure G). 

9. Connect the braided loop over the sound bar on both sides (Figure H). 

10. Connect each of the two supplied braided loop and buckles to the sound bar (Figure I). 
 

11. Connect the front bungee to the windshield footman loop (Figure J). 

Installation Instructions Written by ExtremeTerrain Customer J. Sandlin 05/15/2018.