How to Install Smittybilt G.E.A.R. Front Seat Covers - Coyote Tan (87-18 Wrangler YJ, TJ, JK & JL) on your Jeep Wrangler

1. Remove the seat covers from the packaging (Figure A).

2. Lay out each piece in the sun (this will help reduce wrinkling caused by the packaging) (Figure B).

3. Remove the headrest (Figure C).

4. Position the seat cover over top of the seat back with the Molle threading facing the rear of the vehicle (Figure D).

5. Slide the seat cover down the seat back, pulling on both ends (Figure E).

6. Replace the headrest (Figure F).

7. Pull each set of strings at the bottom tight and move the spring-loaded catch into place (Figure G).

8. Begin installing the Molle system pockets by weaving the rear fabric straps through the Molle threading on the backside of the seat cover (Figure H).

9. Snap the fabric straps back into place (Figure I).

10. Repeat Steps 3-9 on the other front seat.

Installation Instructions Written by ExtremeTerrain Customer J. Sandlin 06/19/2018.