How to Install Smittybilt Atlas Door Step (07-18 Wrangler JK) on your Jeep Wrangler

1. Carefully open the package using a box cutter or knife (Figure A) and ensure the hardware is included and undamaged. 

2. Using a 50 torx bit, remove the bottom bolt of the door hinge.

3. Remove the door from the hinge (Figure B).

4. Using a 50 torx bit, remove the top two hinge bolts (Figure C).

5. Using a 50 torx bit, remove the bottom two hinge bolts (Figure D).

6. Place the Smittybilt Atlas Door Step over the hinges, aligning the holes.

7. Using a 50 torx bit, replace the top two hinge bolts (Figure E). 

8. Using a 50 torx bit, replace the bottom two hinge bolts (Figure F).

9. Tighten all bolts (Figure G). Return the door onto the vehicle door hinge.

10. Return the bolt removed in Step 2.

11. Repeat Steps 2-10 on the other door.

Installation Instructions Written by Extreme Terrain Customer J. Sandlin 03/01/2018.