How to Install Oracle LED Door Projectors - JEEP Logo (87-18 Wrangler YJ, TJ, JK & JL) on your Jeep Wrangler

1. Carefully open the package using a box cutter or knife (Figure A) and ensure the hardware is included and undamaged.

2. Locate the screw-on cap on the LED door projector (Figure B).

3. Using a Philips head screwdriver, loosen the cap (Figure C).

4. Extend the wiring off each LED door projector using different color wires (preferably red for positive ( ) and black for negative (-) (Figure D).

5. Open the driver's side door (Figure E).

6. Using the supplied hole saw drill bit, locate and drill a hole in the underside of the door (Figure F). 

7. Push the LED door projector inside the hole and run the wiring through the door compartment (Figure G).

8. Tap into a positive ( ) wire or directly to the positive ( ) battery terminal with the red wire. Tap into a ground wire or mount to chassis with the black wire (Figure H).

Note: If wanting these LEDs to appear when doors are opened, tap into the 12v wiring between the door and the clip.

9. Tighten the screw-on cap.

10. Repeat Steps 2-9 on the other door. 

Installation Instructions Written by ExtremeTerrain Customer J. Sandlin 05/23/2018.