Free Shipping on Orders Over $75. Details

Talk to Wrangler Enthusiasts
1-877-870-8556
M-F 8:30A-11P, Sat-Sun 8:30A-9P
$4,500 Giveaway! 3 Winners Enter Now

Mammoth Front Adjustable Track Bar (07-18 Jeep Wrangler JK)

Item J106861
ExtremeTerrain no longer carries the Mammoth Front Adjustable Track Bar (07-18 Jeep Wrangler JK). Please check out 2007-2018 Jeep Wrangler JK Track Bars for an updated selection.
Call a Wrangler Enthusiast at 1-877-870-8556
M-F 8:30A-11P, Sat-Sun 8:30A-9P

Features, Video & Details

  • Maintain Correct Geometry
  • Front Adjustable Track Bar
  • Durable Steel Construction
  • 35mm Thick
  • Black Powdercoat Finish
  • Red Polyurethane Bushings
  • Straight Forward Installation
  • Fits 2007-2018 Jeep Wrangler JK Models

Review & Installation Video

Review & Install Video

Adjustable Performance. Maintain your investment by ensuring proper geometry of your front axle. Designed for 2007-2018 Jeep Wranglers, this Mammoth Adjustable Front Track Bar will provide a solid and properly centered front axle to keep your JK on track. This black powdercoated steel bar is fully adjustable and allows for fine tuning, giving you superior performance both on and off-road, especially if your Jeep is equipped with a lift.

Durable Construction. This Mammoth Adjustable Front Track Bar is crafted from a quality 35mm thick steel tubing for extreme rigid strength. Completed in a durable black powdercoat finish to prevent corrosion and rust, you can be sure this front track bar by Mammoth won't flex or cause any unwanted front end wobble once installed. Not only is this Front Track Bar solid, it features red polyurethane bushings that provide a quiet and comfortable ride.

Straight Forward Installation. Designed as a simple installation, you'll just need to remove your factory front track bar and install this Mammoth Adjustable version in its place, utilizing the factory hardware. Make necessary adjustments to your new bar and you're all set, getting back on the road in less than 2 hours from start to finish.

Application. The Mammoth Adjustable Front Track Bar is specifically designed for use on 2007-2018 Jeep Wrangler JK models.

Mammoth 4x4

Fitment: Details

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov

What's in the Box
  • (1) Track Bar
Installation Info
Tech Specs
Will it fit my Wrangler?
  • JK Rubicon 2 Door - 07, 08, 09, 10, 11, 12, 13, 14, 15, 16, 17, 18
  • JK Rubicon 4 Door - 07, 08, 09, 10, 11, 12, 13, 14, 15, 16, 17, 18
  • JK Wrangler 2 Door - 07, 08, 09, 10, 11, 12, 13, 14, 15, 16, 17, 18
  • JK Wrangler 4 Door - 07, 08, 09, 10, 11, 12, 13, 14, 15, 16, 17, 18

    Customer Photos (16) Submit Your Photo

    View All 16 Photos

      Questions & Answers (5)

      5 Top Rated Questions

      Whats the length from mount to mount? Will this fit a 0"-3.5" lift? I installed a high steer kit. I have to down grade from my adjustable but don't want to use my stock bar.

      • The Mammoth Front Adjustable Track Bar is adjustable, so the length between mounting points will vary based on the adjusted length. This track bar is suitable for 0" to 4" lifts.

      Helpful (4)

      Are the bushings replaceable?

      • These bushings are not able to be replaced.

      Helpful (1)

      How many foot pounds of torque for the 15 and 21mm bolts? Thanks.

      • The 21mm bolts will use the OEM torque spec of 150 ft-lbs. The bolts for the adjuster collar will be torqued to 45 ft-lbs.

      Helpful (1)

      I have a 2007 JKU and I just received my front track bar and it looks like it’s going to rub on my front brake lines because my stock track bar is really close to it. Is this a common problem?

      Will I need a wheel alignment after installing this?

      • An alignment is not needed as long as you adjust the track bar properly.

      Helpful (0)
      Post Your Question

        Customer Reviews (41) Write a Review

        Ratings Summary

        4.2 out of 5 overall rating from 41 customers




        • July 20, 2019

          5 2012 Wrangler - Troy

          No more darting

          Heavy duty than factory, adjustable with my 3"lift able to take track bar drop brackets off and no more darting when going over dips or bumps on road..

          Helpful (1)
        • July 14, 2019

          5 2009 Rubicon - RedRockRube

          Mammoth track bar

          What’s to say this thing is mammoth. Installation was simple And the bushings were black.

          Helpful (0)
        • July 08, 2019

          5 2016 Wrangler - GJKU

          Heavy Duty- needed for large tires

          No worries about flex when adding larger footprint tires. Everything has good clearance around axle and suspension components. I upgraded bolts from metric to SAE grade 8 bolts and nuts.

          Helpful (0)
        • June 20, 2019

          1 2009 Wrangler - KyleA

          Bad bushings

          Got and installed which was a breeze, only to drive out of my community and break all four ball joints and cause a bad death wobble. Put on old track bar, hoping that my ball joints was just a stroke of bad luck. Replaced ball joints and reinstalled track bar, along with a new drag link, and tie rod. Steering still felt loose, looked at track bar while someone shimmied the wheel back and forth and you can see how much play it gives. Bad bushings, getting rough country track bar and hoping im done with this issue.

          Helpful (0)
        • May 23, 2019

          4 2014 Wrangler - JHMA1

          Needed for lift and large tire upgrades

          Mammoth Adjustable was priced right- heavy duty construction and exactly what was needed for my 3" lift and 35 inch tire upgrade- did the trick and with alignment rig runs smooth!!

          Helpful (1)
        • May 23, 2019

          1 2011 Wrangler - Russell

          Bad bushings

          Bushings bad out of the box, as a few others have noted. Caused death wobble and had to weld on the brackets to repair ovaled bolt holes. Costly mistake that resulted in premature wear of other components, as well as a lot of time and money spent chasing the issue through the rest of my suspension/steering systems.

          Helpful (1)
        • May 19, 2019

          1 2017 Rubicon - Michael

          Does not do the job

          Made my jeep worse once on. Tried to fix/adjust the bar a few times, ended up putting the old one back on. Waist of money and time.

          Helpful (0)
        • May 10, 2019

          3 2013 Rubicon - Rubicon13

          Ok for price

          Gave three stars because, the adjustment center piece keeps loosening up. Keep an eye on it! Also after installing, I bought the 9/16 bolt upgrade kit. This I recommend, it took all the play out of it!

          Helpful (0)
        • May 09, 2019

          5 2008 Rubicon - Patches

          Mammoth track bar

          This bar is amazing compared to stock! Very easy install.

          Helpful (0)
        • May 08, 2019

          5 2017 Wrangler - TeamJK

          Price point

          Same as teraflex monster forge which I have on my other Jeep. Pound for pound same thing better price

          Helpful (0)
        • May 04, 2019

          1 2015 Rubicon - Tired

          Bad right out of the box

          Just installed my second mammoth bar. Both had bad bushing. When rocking the steering wheel the bar would move in either direction. My mounting holes are not egged out and I went with the 9/16 bolt upgrade. It's a shame I really wanted to like this product but having two bad bars and dealing with install, uninstall, and return hassle I will not be buying from mammoth again

          Helpful (1)
        • April 28, 2019

          5 2018 Wrangler - JohnS

          Great Product

          Went in really easy, performs as advertised, considerably strong and beefy then stock.

          Helpful (0)
        • April 27, 2019

          1 2008 Wrangler - Jesseford

          Bad bushings

          Easy install. Bushings were bad, had death wobbles right after install. Won’t buy again.

          Helpful (2)
        • April 24, 2019

          5 2015 Wrangler - NAVYGOAT

          Does what it said it would

          Bigger then the original the clamps don't move freely up and down the bar which was a bit of a pain. Other then that....EX PZ

          Helpful (0)
        • April 24, 2019

          2 2008 Wrangler - Koolaid

          eh

          cheap but bushings didnt last long at all. will not buy again

          Helpful (0)
        • April 23, 2019

          3 2015 Wrangler - JoeS

          Mammoth track bar

          I bought this cause I had “bump steer” and after I installed it I got death wobble and also the steering wheel turned halfway around. I put the stock one back on and everything went back to normal. Don’t know why this happened and no one seems to help so now I’m out $120

          Helpful (0)
        • April 21, 2019

          5 2007 Wrangler - KimA

          Mammoth front track bar

          Super easy install. Much stronger than stock. Easily adjusted. Love this new track bar.

          Helpful (0)
        • February 23, 2019

          5 2010 Wrangler - Joe

          Great Service and equipment

          Service was great and item was as adverstised. This track bar made a big difference.

          Helpful (2)
        • February 13, 2019

          5 2014 Wrangler - rampage

          no flex here

          very easy to adjust and install really helped straighten out all geometry problems along with correction brackets

          Helpful (3)
        • February 08, 2019

          5 2013 Wrangler - Geckojku

          Very nice for the price

          This track bar is stout. For the price you really can’t beat it. I like that it is adjustable fully installed. It was a little tight on the axle side. Once in the slot it was easy to to align for the bolt. Once both bolts are in adjusting center jeep was pretty easy. I replaced ball joints, track bar, tie rod, and flip draglink at the same time. It drives better now than ever before

          Helpful (4)

        Related Wrangler Categories