Axle Shaft; Rear Left (87-89 Jeep Wrangler YJ)

Keep the Wheels Turning. With the Jeep Wrangler Axle Shaft, you get to keep your rear wheel turning without paying expensive dealership prices. Made to the same specifications as your stock part, this axle shaft fits your vehicle’s Dana 35 rear axle on the driver’s side. It measures 30-7/10 Inches and has a 5 x 4.5-Inch wheel stud pattern to allow for direct installation. The part has 27 inner splines, again mimicking your factory original.

Made to Last. Toughness and durability are essentials for any part that goes into a vehicle used for off-road driving. This axle shaft is made using heavy-duty steel, ensuring it’s capable of withstanding the constant rotation and vibrations that come with taking on the trails.

Expert Installation. The Jeep Wrangler Axle Shaft comes with all of the parts needed to fit it, including seals, bearings, and a set of 5 studs. If you are not an expert mechanic, it’s best to rely on help from a professional to fit this axle shaft. Improper installation voids your warranty and may cause issues for your wheel and axle.

Flexible Guarantee. Crown offers a limited 1-Year or 12,000-Mile warranty, which expires based on which of these two milestones is reached first. Though this warranty excludes damage caused by the owner, it allows returns in cases of material or manufacturing defects.

Application. The Jeep Wrangler Axle Shaft is a replacement part that fits the rear driver’s side axle of Jeep Wrangler YJ vehicles built between 1987-1989. It is not compatible with models that have ABS brakes.

Installation Difficulty. If you’re installing this part yourself, set aside between 2-4 hours for the task. Only attempt installation if you have expert-level practical knowledge of your vehicle’s rear axle.

Fitment:

• 1987 Jeep Wrangler
• 1988 Jeep Wrangler
• 1989 Jeep Wrangler

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov