(approx) 2 Hours
Light to Moderate mechanical skill required.
$195.99 (kit)FREE Shipping
Features, Description, Reviews, Q&A, Specs & Installation
Tire Clearance. The TeraFlex 1.25 inch body lift kit is a simple and cost effective solution for those looking to gain more tire clearance. This lift easily accommodates up to 33 inch tires and can be paired with suspension lift kits for even more clearance. So whether you're on the trail or headed to the mall, this simple lift will give you the clearance you need.
Durable Construction. This Wrangler body lift consists of multiple body lift spacers molded from durable UHMW polyethylene providing superior longevity and resistance against corrosion. This kit comes fully equipped with the necessary hardware for installation, with no modification or grille removal required.
Application. The TeraFlex 1.25 Inch Body Lift Kit is designed for 2007-2018 Jeep Wrangler JK and JK Unlimited automatic transmission models. Manual transmission models will require shifter boot trimming for proper installation.
Fitment: 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 Details
CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
January 30, 2020
Great option for needed tire clearance
Super easy install. Took about an hour. I used the scissor jack on a stack of 2x6 to lift the body. Front is the hardest. You have to lift it to pretty high to a point where it might feel uncomfortable but it is all good. To get that front one in you can jack the body just behind the front wheel. I wasn't able to jack it near the front bolt like you see in the videos. Sway bar gets in the way. Also worth mentioning is the rear bolts are slightly larger than the rest. If you try one of the smaller bolts first and it just spins don't freak out. Grab another bolt. Definitely worth it. I also picked up a bumper relacator which fixed the gap in the back. Can't even tell the lift is a body lift.Helpful (0)
July 09, 2019
Great product. Easy install. Only complaint is there is no warning to say that a shifter extension is required when completed on Jeep with manual transmission. Rough Country has that covered for under 60 USD.Helpful (2)
February 02, 2019
Good for a lower budget lift
The hardware that comes with the kit is top notch, trying to get the existing bolts out of the body mounts, down right suck. You really need to watch the alignment on the front two bolts, they are a pain to get lined back up the first try. Took four times of jacking and lowering to align them. Once it is done, looks great. First side took about 90 min, drivers side was do e in 30 min. Not really and afternoon, but can be done in a few hoursHelpful (4)
January 27, 2019
Added to my 2 inch Mopar lift
Pretty straight forwrad installation, the front two are quite a pain, I found with about 1/4 inch of thread showing above the spacer, you can move the mount and start the threads. it will look a lot better when spring comes and I take off the factory wheels and tires and install my 35's. i spent a lot of time trying to align front mount, only to realize i can move the factory one just enough to start the threads.Helpful (4)
January 10, 2019
I had/have an AEV 2.5 inch suspension lift, but it was not enough. The additional 1.25 inches was perfect and it was as easy as they say. Watch the Teraflex video a couple times then go to it; you will be happy you did.Helpful (6)
December 30, 2018
It’s all good
The kit arrived on time. It went on as advertised without any issues. It appears sturdy and well built. There is no affect on the ride quality. I used a foot long piece of 2x4 in between the jack and underbody near the center most body mounts which lifted each side without the need for two jacks. So far so good.Helpful (6)
December 13, 2018
Great product, easy installation.
I used this to augment my 3.5" suspension lift to clear 38.5" tires. I installed it in my driveway in less than 2 hours, pretty basic design and easy to install. One suggestion I would have for installing would be to nail a 2x4 to a 4x4 to create a T to raise the body if you're using a floor jack like I did. The 2x4 should be about 16" long and sit under the door behind the pinch seam to distribute the force of lifting the body. Happy with the results of the product and the installation.Helpful (7)
June 30, 2018
Easy install. I used a floor jack plus a 4X4 and (5) 2X4's. On my 2 door, I made sure the length of the wood was a few inches shorter than the space between the two middle body mounts. Lift one side up and place all four spacers in one shot. A piece of cake. The Rough Country rear bumper brackets that permit an equal 1.25 inch lift with the bumper was actually just as easy. By no means am I a mechanic either. I usually struggle with anything that has to do with a wrench but these two mods were 1 1=2!Helpful (10)
May 21, 2018
Great kit, not so easy install
I am very pleased with this body lift. It is exactly what I wanted, in addition to the 2.5 in coil lift I already had. I watched the Teraflex install video several times. I used a friend's garage who had a professional lift. Without that I am not sure I would have been able to get it done. The hardest part was the front two body mounts, lifting it high enough to slide the puck underneath the posts, as the install video says is the case. But it had to be high enough that alignment was an issue. After some pushing and pulling, was finally able to get them aligned appropriately. Also, one of the driver side body mount screws was not long enough to grab the threads on the capture nut. Not sure why, as it was the same length as all the others, but had to use another, longer body mount screw that my buddy had in his shop. Make sure you torque the bolts appropriately. The Teraflex install video says to re-torque after 1k miles, but I would suggest sooner, as I had to after only a few hundred miles and a weekend crawling trip.Helpful (10)
May 09, 2018
Overall, good product!
My brother and I installed it in my garage. We used a floor jack, bottle jack and blocks. I already had a 3.5” suspension lift and wanted to sit a little higher and also give myself the option of getting bigger tires later. Keep that in mind if you also have a suspension lift-you will need more jack options. Overall, not bad as far as install. The front 2 are definitely a pain though. Not much room to work with. Other than that, I love the way it turned out!Helpful (7)
Essentially the swing gate would be raised 1.25” but the rear bumper would remain in the stock position, so with this misalignment would this body lift effect the operation of a single action tire carrier?
Yes, this item will cause an issue with a Single Action Tire Carrier.
I have a 2018 jk with 2.5 suspension lift and Fox shocks, if I add this body lift is there anything else I would need to add to keep all parts aligned?
This item will come with all parts needed to install and no other parts would be needed to work with the lift kit.
Just installed this on a 2017 2DR Willy’s Edition. Saw that I may need to trim the shifter boot but the problem isn’t just the boot. Took the boot completely off and the shifter rod is hitting the center console and won’t go into 2, 4, 6 or R. Besides uninstalling and returning any suggestions?
The Teraflex 1.25 in. Body Lift is intended for Use with Automatic Transmission- not manuals.
Is this item for a 2 door or a 4 door?
The Teraflex 1.25 in. Body Lift will fit both the 2-Door and 4-Door Model Jeep Wrangler JK's.
Will this fit a UK 2.8crd Diesel 4door JK
We have not tested this part on the UK models and cannot confirm fitment.
The Teraflex 1.25 in. Body Lift will provide clearance for 33's but with stock wheels, you will rub on the sway bar at full steering lock.
It would not be recommended to pair a body kit with a leveling spacer kit.
This item should not create any issue with any driveline or suspension parts. You can use with your current lift.
No discernable gapping can be noticed after installation.
Yes, the Teraflex 1.25 in. Body Lift will fit your 6 speed JKU. It will require shifter boot trimming for proper installation. This kit should allow you to clear one tire size larger than your current lift set up. You should be able to run 36s, possibly 37s with the addition of flat fenders to allow for extra clearance.
Yes, the Teraflex 1.25 in. Body Lift will fit your 6 speed JKU. It will require shifter boot trimming for proper installation.
Yes, the Teraflex 1.25 in. Body Lift will work with both an automatic and manual transmission. If you have a manual, it will require shifter boot trimming for proper installation.
The Teraflex Front Swaybar Quick Disconnect Kit and the Teraflex 1.25 in. Body Lift should not interfere with one another and should be compatible without any issues.
The Teraflex 1.25 in. Body Lift will work with the Teraflex 2.5 Suspension lift. Total lift would be 3.75" with both kits.
Hello, on the Teraflex 1.25 in. Body Lift (07-17 Wrangler JK) it is possible to use this in conjunction with the leveling kit with no added any extra parts.
(approx) 2 Hours
Light to Moderate mechanical skill required.
What's in the Box
Manual transmission models will require shifter boot trimming for proper installation