Your Driveshaft, Secured.
When you’re taking your 2007-2018 Jeep Wrangler JK on the trail, the wear and tear it causes may end up making your ride looser than you want and way earlier than you expected. So when you need to keep your ride steady, install this JKS Front Track Bar & Sector Shaft Reinforcement Kit for 2+ in. Lift. This modification allows you to secure your track bar, allowing for higher load capacity if you’re wanting to mount bigger tires with a rock solid ride.
Bigger, Badder, Better.
This track bar kit is forged from solid steel that is far stronger than any factory pieces you have on your Wrangler. The modified track bar and track bar bracket are far tougher than stock, and prevent early bushing wear and the dreaded death wobble due to your stock track bar warping for lifted suspensions of two inches or higher.
The Support You Need.
This kit provides a way for your Wrangler to equally distribute the power and stress you put your suspension under while driving to both chassis rails instead of favoring one or the other. Of course, this will give you greater control while on rough patches of trails, and the confidence you need to keep blazing forward.
This kit does require welding. So, you will need hand tools, a car lift or jack stands, and welding supplies. In addition, you will need advanced mechanical knowledge and the experience necessary to handle those tools. Installation will take about two hours. Please have this installed professionally if you lack the tools or expertise to install.
Limited Lifetime Warranty.
This kit is protected by a limited lifetime warranty protecting against material and manufacturer’s defects. Please see Zone Off Road’s full warranty for complete details.
This JKS Front Track Bar & Sector Shaft Reinforcement Kit for 2+in Lift is designed to fit all 2007-2018 Jeep Wrangler JK Models. Please ensure correct model before purchase.
CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov