How to Install a M.O.R.E. Dead Pedal on your 2007-2017 Jeep Wrangler JK

* M.O.R.E. Dead Pedal Drivers Side (07-15 Wrangler JK) Item # J25070
*Passenger side dead pedal
*2 bolts, 2 washers, 2 locking washers

Please note that Drivers Side Dead Pedal only works with AUTOMATIC TRANSMISSIONS

*M.O.R.E. Dead Pedal Passengers Side (07-15 Wrangler JK) Item # J25071
*Passenger side dead pedal
*2 bolts, 2 washers, 2 locking washers *10mm socket

Step 1: Remove the cable restricting door opening. 

Step 2: Remove the cable for electronics (if applicable). Be careful not to allow door to swing

Step 3: Remove the 2 bolts with a 10mm socket attached to the bracket for holding the door opening restrictor. You will not need these bolts but it is recommended to keep the stock hardware in case you want to take off the dead pedal.

Step 4: Remove the 2 nuts with a 10mm socket attached to the ground wires. Leave the ground wires on the screw posts. Keep these nuts – you will need these at the end.

Step 5: Place the dead pedal on the screw posts. There are 3 separate adjustment levels for the dead pedal. Choose one and hand snug the nuts back to the posts. Test the level of the dead pedal, and move to desired level before moving on.

Step 6: Turn the ground wires straight up so that the wires fall into the cut out on the bracket. Hand snug the nuts to the ground wire posts.

Step 7: Make sure that the door opening restrictor plate is behind the dead pedal. Take the supplied bolts, add the locking washers, then the other washer. Hand snug the bolts.

Step 8: Using the 10mm socket, tighten down the 4 bolts.

Step 9: Replace the electric wires to the harness and the door open restrictor to the bracket. Enjoy!

Installation Guide written by ExtremeTerrain Customer Michael Marcantonio 10/11/2014