Excessive Industries Comp Series Front Bumper with Stinger Bar; Bare Steel (97-06 Jeep Wrangler TJ)Find parts that fit my vehicle

Low-Profile Strength. The Excessive Industries Comp Series Bumper delivers trail-ready protection and recovery utility for 1997–2006 Jeep Wrangler TJ models, pairing a compact footprint with serious front-end reinforcement. Built as a direct replacement, it’s designed to take hits, clear obstacles, and provide dependable attachment points so your rig stays protected when the terrain turns technical.

Construction and Appearance. This front model arrives in a bare steel finish that’s ready for your choice of coating—powder, paint, or bed liner—to match your build and resist corrosion. A welded stinger bar adds forward protection and helps prevent end-over pitch on steep drops, while recessed shackle points sit tight to the bumper body for clean approach angles and strong, straightforward recoveries. The structure emphasizes thick wall sections, gusseted junctions, and precise welds to keep the assembly rigid under winching loads and trail impacts.

Installation. A bolt-on layout and included hardware make for a straightforward, versatile installation using common hand tools. Dry-fit the bumper and stinger, square gaps to the grille and fenders, then snug fasteners before final torque to ensure even alignment. Because the finish is bare steel, proper surface prep and coating are recommended prior to mounting; this seals the metal against moisture and road salts and delivers a longer-lasting, professional look once installed.

Application. This Excessive Industries Comp Series Bumper fits 1997-2006 Jeep Wrangler TJ models. By combining a protective stinger, recessed recovery points, and a compact profile, it sharpens approach angles, streamlines recoveries, and fortifies the front end for tougher trails and confident daily driving.

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov