FREE 1 to 3-Day Delivery on Orders $119+ Details
Remove the rear tire and the (8) 13mm bolts holding the tire carrier to the tailgate.
Disconnect the third brake light harness, which can be access through the rear panel of the tailgate.
Remove the (4) 15mm bolts securing the rear bumper.
Install the mounting bracket to the inner side of the rear bumper support beam, slide the bolts through, leaving the nuts off.
Next, slide the L-Shaped mounting brackets into the frame rails with the nut backing up to the predrilled hole in the frame.
Slide your new rear bumper over the brackets and bolts set in place in the previous steps.
Thread the (4) supplied bolts into the side bumper supports and tighten.
Using the supplied nuts, install the center support and tighten.
Install the swing arm by sliding it over the post on the bumper. *Note it may help to grease the post for smoother operation.
Install the top cap then secure it with the supplied allen-head bolt.
Slide the latch into the end of the swing arm and secure with the two bolts and nuts.
Finally, install the rear tire carrier and secure it to the rear swing arm at the desired height using the supplied hardware.