Guaranteed Free Delivery by 12/24! available on most items - Details
How to Install a Barricade Corner Guard on your 1997-2006 Jeep Wrangler TJ
Installation Time
3 hours
Tools Required
- 18mm Wrench
- 9/64” Allen Wrench
- 3/8” Drill Bit
- Drill
Shop Parts in this Guide
Tools Required:
Parts List:
(1) Left Guard
(1) Right Guard
(24) 9/64 Allen Bolts
(24) 1/4” washers
(24) 18mm Locknuts
Step 1
Remove the rear factory flares. Refer to dealer guide or if using aftermarket fender flares follow the manufacturers guide.
Fig. 1
STEP 2
Remove factory fuel filler surround, taillights and license plate assembly.
Fig. 2
STEP 3
Temporarily lay the guards over the sheet metal, use the pre-drilled holes in a guard as a guide to mark the mounting holes. Using a 3/8" drill bit, drill the corresponding holes into the vehicle.
Fig. 3
STEP 4
Attach the guards to the vehicle using the supplied Allen bolts, washers, and locknuts.
Fig. 4
STEP 5
The longer bolt inserts into the lower left (drivers side guard) / lower right (passenger side guard).
Fig. 5
STEP 6
If you aer installing fender flares, line up the fender flare to the guard and drill the respected bolts for installation.
Fig. 6
STEP 7
The installation is now complete. Reattach all components.
Fig. 7
