FREE 1 to 3-Day Delivery on Orders $119+ Details
How to Install ZRoadz 6 in. Single Row Slim Line Straight LED Light Bar - Flood Beam on your Jeep Wrangler
Installation Time
60 minutes
Tools Required
- Box Cutter/Knife
- Wiring Harness
- 10mm Socket
- Socket Wrench
1. Attach a positive wire from a wiring harness to the positive terminal of the battery (Figure A).
Figure A
2. Attach a negative wire from a wiring harness to the negative terminal (Figure B).
Figure B
3. Remove the support bolt from the LED light bar (Figure C).
Figure C
4. Place the bracket onto the support bolt (Figure D).
Figure D
5. Place the nut back on the support bolt (Figure E).
Figure E
6. Tighten the nut on the support bolt completely.
7. Repeat Steps 3-6 on the other side of the LED, as well (Figure F).
Figure F
8. Mount the bracket to the vehicle on both sides (Figure G).
Figure G
9. Run the wiring harness to the mounting location (Figure H).
Figure H
10. Connect the wiring harness to the LED (Figure I).
Figure I
11. Connect the wiring harness to a switch (not supplied).
Before
After
Installation Instructions Written by ExtremeTerrain Customer J. Sandlin 07/15/2018
