FREE 1 to 3-Day Delivery on Orders $119+ Details
How to Install T-REX ZROADZ Series Grille w/ Single 10 in. Center Mounted Slim LED Light Bar on your
Installation Time
2 hours
Tools Required
- Phillip/ Slotted Screwdriver
- Needle Nose Pliers
- 8mm Socket
- Die Grinder/Cut off Wheel
Lay out your parts. From the backside of the grille, put into place the ZROADZ Logo Backing Plate.
Lay out your parts. From the backside of the grille, put into place the ZROADZ Logo Backing Plate.
Put into place one of the Bracket Tabs and seucre with provided Hardware as seen in Fig. # 2-4 and then from the backside of grille position LED Light Bar.
Put into place one of the Bracket Tabs and seucre with provided Hardware as seen in Fig.
STEP 3 ":With LED Light placement set, put into position the remaining bracket and the finally tighten LED and all Mounting Brackets into their final secured position.
From the face side of grille slip the LED Light bar into place. On the opposite side, position the remaining bracket and finally tighten LED and Brackets into position. There is a final step for both styles of ZROADZ Grilles. See both of the Figure #8 Images and note that there is an exposed hole. Use the Provided Hardware Button Head Screw and fill the hole and tighted down with Nut. This will create symetrical look from side to side.
Hardware / Parts List:
1 Grille
7 1/2" x 135 L Brackets
7 6-32 Nylon Lock Nuts
Step 1
Read and understand all instructions before attempting the install of this grille. Be sure that the package of hardware matches the hardware list as listed above. Next, test fit the T-REX grille to the vehicles factory openings. You are now ready for the install:
Step 2
Using the needle nose pliers; unclip the harness to the factory turn signals. These can be accessed through the wheel wells. Remove the upper factory pop clips holding the grille to the vehicles core support (1). By pulling on the bottom center of the grille; this will release the four lower grille clips. Remove the grille from the vehicle and place on a soft surface to prevent damaging your factory grille.
Step 3
If the grille is equipped with a one piece factory mesh; remove the mesh by removing the screws and U clips on the bottom of the grille. Cut the center vertical bars from the grille shell (2). Sand the edges of your cut marks till smooth. Check your grille insert in the shell. Trim the necessary areas for the insert to fit properly. From the backside of the grille; place an L bracket and nylon lock nut on each stud (3). With the grille centered; tighten all of the hardware.
Step, 4
Replace the grille and all hardware. Reconnect the fog lights. Make sure all hardware is secure.
