How to Install Teraflex Rear Shock Offset Extension - Pair on your Wrangler

Important Notes:

beginning this or any installation read these in-structions to familiarize yourself with the required steps and evaluate if you are experienced and capable to per-sonally perform these modifications.  Refer to 

the parts list to ensure that all necessary compo-nents and hardware has been included. If any parts are missing please contact your local retailer for assistance.

1. Remove the rear shocks.  

2. Locate and install the left rear shock extension. Using the supplied 5/16” bolt and nut, hold the extension bracket into place. Start one of the M10 x 90 mm long bolts. (Figure 1)  

3. Slide the shock bar pin into place. Install the other bolt and torque both M10 bolts to 37 ft-lbs. Tighten the 5/16” bolt. (Figure 2)  

4. Install the bottom end of the shock into the shock bracket on the axle. Torque the bolt to 56 ft-lbs when the vehicle is sitting at ride height. (Figure 3 & 4)  

5. Repeat for the other side.