FREE 1 to 3-Day Delivery on Orders $119+ Details
How to Install Teraflex 2 in. Lift Kit w/ Shocks on your Wrangler
Important Notes:
Prior to beginning this or any installation read these instructions to familiarize yourself with the required steps and evaluate if you are experienced and capable to personally perform these modifications. A factory service manual should be used in conjunction with these installation instructions.
This product will change the handling characteristics of your vehicle, drive with caution. A full four-wheel alignment is required after the installation of this product. We recommend your local, ASE Certified mechanic.
Refer to the parts list to ensure that all necessary components and hardware has been included. If any parts are missing please contact your local TeraFlex dealer for assistance.
REMOVAL
1. This install can be performed with the vehicle sit-ting on the ground. Make sure it is safely support-
2. Remove from the axle bracket with either a T50 torx or a 17mm.
INSTALLATION
With the steering wheel centered, bounce the Jeep up and down. Use the bumper for this. Without moving any other components, raise the end of the track bar up into it’s mounting bracket.
If you have room in the bracket so the hole does not overlap, go ahead and drill a hole with a 13/32” drill bit. If you drilled in the correct location the bar should line up with the new hole.
Insert the new 10mm x 75mm bolt. Torque to 40 ft-lbs.
