How to Install Smittybilt Bowless Combo Soft Top w/ Tinted Windows on your Wrangler

Note: Read instructions entirely before installing this product. It is recommended to install this product when temperatures are above 75 degrees. If temperatures are below this; the material can contract up to an inch. Wrinkles from packaging will go away once the material relaxes. Vehicle picture mav varv from vour actual vehicle.

NOTE: You will need to have the following to install this part correctly.
1. Windshield Header ( Smittybilt Part #90104 TJ, # 90105 JK )
2. Tailgate retaining bar and brackets.
3. OE Door Surrounds

Step 1: Remove your hardtop or soft top and bow assembly. (If equipped).
Step 2: JK- Lay the center extended top section on a clean surface. Remove the knobs and latch Bracket from your header and then slide header into the front of the top. Connect the snaps on the top to the ones on the header. (Fig A, B)
TJ- Mount header on TJ windshield frame per header instructions.
Step 3: Lay the header on top of the windshield frame and spread top back over vehicle. (Fig C)

Step 4: Reattach the brackets to the header using the knobs (JK) or clamps (TJ) previously removed and secure the header. (Fig D). TJ: Slide plastic channel into header. It helps to keep slight tension to keep it in place.

If you have a 2010-2014 model you will need to make a small modification to the door surrounds. To utilize the channel on the top part of the door surround you will need to remove the added extrusion on them by removing the staples that hold them on. FIG (E,F,G, AND H.)