How to Install a Rugged Ridge Gray Front Neoprene Seat Vest Pair on your 07-18 Jeep Wrangler JK; 2018 Jeep Wrangler JL

Parts included: 

(1) Front driver's side seat protector
(1) Front passenger's side seat protector

Warning: ABS air bag must not be covered by seat protector. Make sure that deployment area is clear of any and all obstructions.

Step (1) Slide, and tilt back of seat forward

Step (2) Remove Head rest

Step (3) Slip protector over back of seat

Step (4) Slip lower nylon strap and
clip between the upper and
lower portions of the seat.

Step (5) Slip Velcro straps through
lower straps plastic loops as
shown.

Step (6) position the side straps in      front of seat adjuster as shown.      Driver's side adjust seat up as high as possible using the seat height adjuster lever. Slip straps between raised seat and seat riser. Clip straps together and adjust. DO NOT OVER TIGHTEN.      

Passenger's side place the rear      strap underneath the seat slider and and seat riser. Adjusting the seat      forward or backwards may help      with locating and pulling inner      most tabs near console. The front      straps should be run under the front    of the seat just behind the seat slider adjustment arm. Adjust straps but      DO NOT OVER TIGHTEN!      

Step (7) Slide front and rear lower straps under seat. This step is the same for both the driver's side and    passenger's side seat protector.      Make sure that the front straps      are inserted through the front seat      adjuster arm to insure proper      operation of seat slider. Clip and adjust. DO NOT OVER TIGHTEN!     

Step (8) Adjust all protectors straps for snug fit and pull onto seat in desired position and make sure the protectors opening DOES NOT BLOCK the seats ABS deployment area. Reinstall head rest and adjust seat back to desired driving position.