How to install a Rugged Ridge Billet Aluminum Transfer Case Shifter Knob in your Jeep Wrangler

Contents: Shift Knob (1)

Step 1. Removing the factory transfer case shift knob. Set the emergency brake. Start the vehicle and place the transfer case into the neutral position. Turn vehicle off. Apply upward pulling force to disengage knob from shaft.

Step 2. Install the new shift knob onto the post. Ensure the shift pattern is orientated correctly.

Step 3. Tighten the set screw. Start the vehicle and cycle transfer case into all modes to verify a tight fit. Place transfer case into normal operating position. Test handle to ensure proper function before operating vehicle.