FREE 1 to 3-Day Delivery on Orders $119+ Details
How to Install Rigid Industries Ignite Surface Mount LED Light - Flood Beam on your Jeep Wrangler
1. Align the Surface Mount LED Light to the GoPro mount (not included) (Figure A).
Figure A
2. Press firmly until the two mount extensions from the LED Light are fully flush with the three GoPro mount extensions (Figure B).
Figure B
3. Thread the GoPro mount screw in and ensure it runs through all five holes (Figure C).
4. Tighten the GoPro screw down to secure the LED Light to the GoPro mount (Figure D).
Figure D
5. Connect a light harness end (not supplied) to the LED Light's black and red (negative and positive) wires (Figure E).
Figure E
6. Run the wiring harness (not supplied) to the battery, switch, and LED Light mounting location(Figure F).
Figure F
7. Connect the light harness end to the wiring harness (Figure G).
Figure G
Before
After
Installation Instructions Written by ExtremeTerrain Customer J. Sandlin 09/14/2018
