FREE 1 to 3-Day Delivery on Orders $119+ Details
How to Install Rigid Industries E-Mark Dually LED Cube Lights - Spot Beam - Pair on your Jeep Wrangler
1. Run the included wiring harness to the engine bay. Connect the black wire to the negative (-) battery terminal using a 10mm socket wrench (Figure A).
Figure A
2. Connect the red wire to the positive ( ) terminal (Figure B).
Figure B
3. Run the wiring harness into the vehicle cab and connect the solid red wire to the bottom switch terminal (Figure C).
Figure C
4. Connect the black and red wire to the middle switch terminal (Figure D).
Figure D
5. Connect the final red wire (to the LEDs) to the top switch terminal (Figure E).
Figure E
6. Run the light harness to the LED mounting location (Figure F).
Figure F
7. Connect the LED to the light harness (Figure G).
Figure G
8. Repeat Steps 6 and 7 for the other LED.
Before
After
Installation Instructions Written by ExtremeTerrain Customer J. Sandlin 08/30/2018
