FREE 1 to 3-Day Delivery on Orders $119+ Details
Remove hardtop.
Refer to vehicle manufacturer's manual for removing the hardtop.
Masking tape.
Apply masking tape to curved outer surface of hartop.
Track positioning.
Edge of track can be used to mark a straight line.
a. Measure 24mm from tangent of hardtop radius front and rear. Mark drilling centreline.
b. Front of track. Measure 160mm from front where the rubber seal meets.
2dr track mounting holes.
Drill 4 holes through hartop at measurements shown.
Track positioning.
Edge of track can be used to mark a straight line.
a. Measure 16mm from tangent of hartop raius at front, front edge of track hangs over on inside a little.
Measure 26mm from tangent of hardtop raius at rear. Mark drilling centreline.
b. Front of track. Measure 140mm from front where the rubber seal meets.
4dr track mounting holes.
Drill 6 holes through hardtop at measurements shown.
Drilling of hardtop.
Drill through perpendicular to the surface using a 6.5mm drill bit. Remove masking tape. Clean hardtop
Attch O-rings.
Install rubber O-rings onto each square head bolt. Locate bolts in the C-groove on underside of track.