How to Install ReadyLIFT 1.5 in. Billet Aluminum Leveling Kit - Anodized Blue on your 07-18 Jeep Wrangler JK; 2018 Jeep Wrangler JL

Securely raise vehicle off ground and remove (4)wheels

Support front axle and remove upper trac bar bolt.

Loosen (2) front transfer case skid plate bolts.

Disconnect dr./pass. lower front swaybar end links

Disconnect and remove front lower shock hardware.

Carefully lower front axle enough to remove front spring

Assemble the desired amount of lift (1.0”, 1.5”, 2.0”) based on the vehicle’s stance.
Note: Config. C requires installation of (4) countersink assembly bolts.

Remove the upper spring isolator to expose mounting hole

T6-6091 & T6-6092 spring spacer kit w/mounting hardware

Attach spring spacer kit with provided hardware

Tighten bolt and reinstall rubber isolator as shown

Reinstall coil spring in vehicle and raise axle

Reattach lower shock mount and tighten

Reconnect lower swaybar endlinks and trac bar bolt

Tighten transfer case skid plate bolts, reinstall wheels