Free Shipping on Orders Over $75. Details

Talk to Wrangler Enthusiasts
M-F 8:30A-11P, Sat-Sun 8:30A-9P

How to Install Raxiom 14 in. C3 LED Light Bar on your Jeep Wrangler

Installation Time

60 minutes

Tools Required
  • 10mm Socket
  • Socket Wrench
Extreme Terrain
Shop Parts in this Guide

1. Set the supplied wiring harness out (Figure A).

Figure A

2. Attach the black wire to the negative battery terminal (Figure B).

Figure B

3. Attach the red wire to the positive battery terminal (Figure C).

Figure C

4. Run the pre-wired light switch into the cab (Figure D).

Figure D

5. Place the supplied stand leg in place alongside the LED (Figure E).

Figure E

6. Thread a supplied bolt through the stand leg and into the LED and tighten using the supplied Allen wrench (Figure F).

Figure F

7. Run the light harness wire to the LED mounting location (Figure G).

Figure G

8. Connect the LED to the light harness (Figure H).

Figure H



Installation Instructions Written by ExtremeTerrain Customer J. Sandlin 08/30/2018