Free Shipping on Orders Over $75. Details

Talk to Wrangler Enthusiasts
M-F 8:30A-11P, Sat-Sun 8:30A-9P

How to Install Poison Spyder Roller Fairlead Light Mount - Textured Black (07-18 Wrangler JK) on your Jeep Wrangler

Tools Required
  • Fine-tip felt marker
  • Center punch and hammer
  • Drill motor with 3/8” drill bit
  • 7/32” hex key socket and ratchet
  • 9/16” combination end wrench
  • Torque wrench
Extreme Terrain
Shop Parts in this Guide

The Poison Spyder Customs Roller Fairlead Light Mount is a simple way to add two auxiliary lights to most off-road vehicles equipped with roller-type winch fairleads. This mount is designed to work with most Warn and late model Ramsey roller fairleads, and will also work with many other brands.

Installation is fairly simple with the right tools and good mechanical abilities. If you are not confident in your mechanical skills, please seek the help of a professional to perform the installation. Please read through these entire instructions before proceeding with installation.

Parts list

(1) Roller Fairlead Light Mount
(2) 3/8-16 X 1 SS button head cap screw
(2) 3/8-16 nylon insert lock nut

Installation Procedure

1. Place the Roller Fairlead Light Mount on top of the roller fairlead and check for any clearance issues. Use the fine-tip felt marker to mark the two 3/8” hole locations in the top flange of the fairlead, using the Fairlead Light Mount as the template.

2. Remove the bracket and set it aside. Use a center punch and hammer to punch the centers of each of the hole marks made in Step 1. Drill each of these holes with the 3/8” drill bit.

3. Use the supplied stainless steel button head cap screws and lock nuts to fasten the Roller Fairlead Light Mount to the roller fairlead. Make sure the button head is on top, with the lock nut underneath (inside) the top flange of the roller fairlead. Torque to 15 ft.-lbs.

4. Install your auxiliary lights to the mounting holes in Roller Fairlead Light Mount, and wire according to the instructions for your lights.