How to Install PIAA Fog Light Mounting Bracket Kit (07-17 Wrangler JK) on your Jeep Wrangler

1. Remove the stock PIAA bracket that comes on the LP530 LED's with a screwdriver. Image #1      

2. Use existing hardware and install new supplied Jeep bracket onto PIAA LP530 lamps. Make sure that portion of the bracket with two holes is at the top of the PIAA lamp.(note: at this time the lamp depth should be set. Notice the holes in the bracket are slotted for front to back movement. The lamp should be installed to the furthest forward point for best fitment but tolerances will vary on vehicles. Properly tighten the hardware to the lamps; you will be able to aim the lights by hand after wiring and installation.)Image #2 

3. Remove the plastic push pins from the top bumper protector and the bottom plastic skid plate. Image #3 

4. Use a 15mm socket to remove the 4 bolts on each side of the metal bumper brace. Image #4 

5. With the bumper removed from the Jeep you can now remove the metal brace and install the PIAA lamps. Using supplied hardware (1/2" metal screws ) install the lamps and brackets as shown. Make sure you install the bracket with the two holes towards the top of the bumper. *Do not over tighten the screws, as they are going into plastic. Image #5 

6. When the lights are properly mounted into the bumper you can now re-install the metal bumper brace and bumper to the vehicle with the bolts you removed in step 4. 

7. Now you are ready to wire the lamps, see page 4.

8. After wiring you can now aim the lamps while they are in the bumper. In step 2 you should have tightly secure the lamps to the bracket but you can still adjust the lamps up and down slightly. Refer to page 5 for lamp aiming guide.