How to Install PIAA 410 Series 3.5 in. Square White Halogen Lights - Driving Beam - Pair on Wrangler

•Lighting laws vary state to state, check your local laws before use.
• TM4amp5^get-very-h©t when they have been-in use. "Do" hot touch them as they may cause burns,,
• After the lights have been on do not place them near flammable objects,
• Do not splash water directly on the hot lamps, as this may cause cracking of the lens due to dramatic change in temperature.
• Do not look directly into the light of the lamps as the br ight light may cause eye damage.,
• The lamps and r elay har ness are to be used only with 12 volt automotive electrical systems.
• Using this light system while the engine is not running will drain the battery,
• Do not repeatedly tur n the light system on and off as it will shorten the life of the system,,
• Some automobiles generate high voltage at start up and when it is turned off, do not have lights on as you start or tur n off your vehicle,.
» Using the wrong bulbs may cause a malfunction, use only specified PIAA bulbs,
• When changing bulbs or lenses follow the lamp assembly/disassembly diagram,,
• Leave at least 1/8" clearance between the lamps and the front spoiler, as the heat may damage the spoiler,

When connecting the wires on the harness, follow the wiring diagram and the sequence below.
(1) Befor e connecting any wires disconnect the negative (-) battery ter minal..
Note: When running the wires through the engine compartment sure to keep them securely away from moving parts such as the fan and the throttle cable and away from hot parts such as the exhaust manifold.

(2)Find a power source to connect the switch power wire to. For legal operation of dr iving lights, the power source must be one that is only powered when the high beam of the headlamps is on ,To make this connection use the supplied connector or any connector that is suitable for this application,, Do not connect lights to turn signals or to lights that flash with an automotive alar m.

(3) Run switch wires into driver's compartment. If wir es pass through the fire wall a r ubber grommet must be used, Connect switch to switch wires and mount switch in desired location.

(4) Connect relay ground to chassey or battery negative (-).

(5) For proper lamp operation it is recommended that you connect the positive ( ) and negative (-) power supply wires directly to the cor responding battery ter minals. Do not take power directly from the alter nator.

(6) Carefully connect harness to bulbs,

(7)When the wir ing is complete, test the system for operation. Do this by tur ning on the system. If the system wor ks, securely fasten the r elay boxes and fuse holders or tie them out of the way with wire ties. If the system does not come on, please contact your PIAA dealer for assistance.

(8) Aim lamps according to Light Aiming instructions on page 5.

(9) Tighten all fasteners.,

Typically, driving lights are mounted above the front bumper about 14-30 inches from the ground to provide extra high beam illumination,, Driving lights can be mounted below the bumper, although they will not be as effective because the light will hit the ground sooner and reduce the range of the light,

Visual aim is made with the center of the beam hot spot 1.5 inches below the lamp center at 25 feet with the lamp facing straight forward, (see below.)

CAUTION

Do not use driving lights into oncoming traffic.
Driving lights should never he the only foreword light source.
Driving lights should only be used with the headlamp high beams.