FREE 1 to 3-Day Delivery on Orders $119+ Details
How to Install Off Camber Fabrications by MBRP Bumper Light Bar/Grill Guard (fits all OCF JK Bumpers
PLEASE READ BEFORE STARTING INSTALLATION
While MBRP Inc. hos mode every effort to ensure that all components of this kit are of superior quality and properly packaged, it is the installer's responsibility to ensure the following before starting:
• that ALL components shown above ore present.
• that ALL mating components fit together.
• that there are no damaged components.
• that the kit you have purchased is appropriate for your year and model of vehicle_
• that the kit will not interfere with or modifications previously- installed or planned,
• that you have read and understand these instructions.
lf you hove any questions or are uncertain about any aspect of the installation of this kit on your vehicle please contact your dealer before commencing installation.
2007-2013 Jeep JK Bumper Light Bar Kit
If you plan to wire up lights, The Wiring can be hidden by drilling the top face of the bumper to allow the wiring to pass through from inside the Light Bar.
Loosely Place the two Gaskets between the Light Bar and the top face of the bumper.
While holding the Light Bar in position on the bumper, install the supplied 1/2" Hex Bolts, and 1/2" Washers from the underside of the bumper and thread them into the Light Bar
Align the profile of the Gaskets with the Light Bar tube and tighten the fasteners.
Install the Grommets into the wiring holes on the Light Bar.
Congratulations! You are finished.
