Talk to a Wrangler Sales Tech
1-877-870-8556
M-F 8:30A-11P, Sat-Sun 8:30A-9P
Logo Image
$20K Sweeps! 10 Chances to Win! Enter Daily >

How to Install Off Camber Fabrications by MBRP Clearance Adapter for Y-Pipe on your Wrangler

Installation Time

2 hours


Modification to Stock System:

Note: This Clearance Adapter is intended to be used on a lifted vehicle to give the front axle more clearance.


1. Locate the passenger side section of the Y-Pipe just before it joins the driver’s side pipe. Using the Clearance Adapter as a guide mark where the ends of the pipe will be located. Measure 2” inward to allow for the existing pipe to go into the expanded area of the pipe. Refer to Figure 1.


2. Remove the heat shield where necessary. Reuse the Y-Pipe Drop Section to check the location of the cuts. Ensure they will fit well inside the expanded area of the Clearance Adapter pipe. Cut and remove the section of pipe. De-burr the stock pipe after cutting.

Installation

1. Install the Clearance Adapter using the 2”Band Clamps provided. Tighten clamps in place. A tack weld is recommended to keep the Clearance Adapter slipping on the stock pipe. Refer to Figure 2.​