FREE 1 to 3-Day Delivery on Orders $119+ Details
How to Install Mopar Tubular Front Bumper - Chrome (07-17 Wrangler JK) on your Jeep Wrangler
Note: Vehicles with fog lamps must disconnect and secure wire harness to vehicle using tie wraps or electrical tape, not included in kit.
Note: Save OEM bumper assembly and fasteners for re-installation.
1. Remove four (4) plastic fasteners in front and rotate splashshield rearwards. Do not remove rear fasteners.
2. Remove outer (4) screws, 2 per side, to disassemble fascia from bumper beam.
3a. Vehicle with towhooks save hardware for Step 5a.
3b. Vehicle without towhooks save hardware for Step 5b.
4.
5a. Vehicle with towhooks.
5b. Vehicle without towhooks.
6a.
6b.
7. If splashshield is to be installed it must be trimmed along dashed lines shown.
8. Install (2) U-nuts.
9. Raise splash shield behind bumper and align holes to insert center two (2) bolts into U-nuts.
10. Use holes in bumper as a template, mark the splash shield to locate outer holes. Remove splash shield and drill 7/16" diameter holes.
11. Do not drill through bumper. Install two (2) U-nuts.
12. See Step 9.
Splash shield may be trimmed many ways, it is up to customer's discretion for desired appearance.
Fog lamp replacement. Fascia with fog lamps use Mopar Part Number 82209880 (fog lamps kit) and 82210217 (fog lamp kit complete).
Plug holes with item "E" for no installation of fog lamps.
Round holes in bumper face are provided to install license plate using included hardware (items G & F).
