Free Shipping on Orders Over $75. Details

Talk to Wrangler Enthusiasts
M-F 8:30A-11P, Sat-Sun 8:30A-9P

How to Install KC HiLiTES 10 in. C-Series C10 LED Light Bar - Spot/Spread Combo on your Jeep Wrangler

Installation Time

60 minutes

Extreme Terrain
Shop Parts in this Guide

1. Remove the wiring harness from the box and locate the battery terminal connects (Figure A).

Figure A

2. Run the positive (red) wire to the positive ( ) battery terminal under the hood (Figure B).

Figure B

3. Run the negative (black) wire to the negative (-) battery terminal under the hood (Figure C).

Figure C

4. Run the wiring harness through the firewall to the mounting location and connect the white wire to the bottom switch terminal (supplied) (Figure D).

Figure D

5. Connect the blue wire to the middle switch terminal (Figure E).

Figure E

6. Connect the black (ground) wire to the top switch terminal (Figure F).

Figure F

7. Tighten the mounting legs onto the LED light bar using the supplied bolts and Allen wrench (Figure G).

Figure G

8. Run the wiring harness connect to the LED light bar mounting location (Figure H).

Figure H

9. Connect the LED light bar to the wiring harness (Figure I).

Figure I



Installation Instructions Written by ExtremeTerrain Customer J. Sandlin 08/24/2018