FREE 1 to 3-Day Delivery on Orders $119+ Details
Step 1
If installed, remove roof rails from JEEP and place to the side.
Step 2
Align four 55060-00-003 (Panel) and one 55060-00-004 (Front Panel) and bolt each panel to one another using three 5/16" x0.75" carriage bolts, three 5/16" flat washers and three 5/16" NYLOC nuts.
Step 3
Around the perimeter of the platform, bolt a 5/16" x 0.75" carriage bolt, a 5/16" flat washer and a 5/16 NYLOC, The head ofthe carriage bolt should be outside of the platform with the flat washer and NYLOC underneath the panels.
Do this on both sides of five panels put together in previous step. (Total of 20 carriage bolt assemblies)
*Finger tighten
Step 4
Slide the 60" extrusion down the side of the platform picking up all 10 carriage bolt heads. Repeat on both sides.
Be sure to have access hole in extrusion perpendicular to panels.
*Panel not shown
Step 5
On the extrusion, slide three offset T-Nuts opposite of where the carriage bolts were installed.
Bolt 55060-00-006 (clamp) to extrusion in desired location using a 5/16" x 5/8" Button Head Cap Screw and the T-Nut.
Repeat on both sides
*When installing the clamps, keep in mind of other accessories you may want to place on your JK STEALTH RAK and position clamps accordingly.
*Remove outside of clamp and TIGHTEN 5/16" x 5/8" button head cap screw.
Step 6
Bolt end caps to both ends of each extrusion using a 5/16" x 5/8"
Button Head Cap Screw.
Step 7
Clamp roof rails (55025 or 55026) to both sides of 55060. Apply cap to the 55060-00-006 (clamp) and hand tighten to allow JK STEALTH rak to be adjusted.
Be sure to have the front panel closest to the bend in the roof rails.
*The bend side of the roof rails attach to the 55015( A-Frame).
Step 8
Place platform and roof rails onto the roof of the JEEP.
Center roof rails and JK STEALTH rak on JEEP. Once centered attach roof rails to 55015(A-Frame) and 55026 (JK Rear Hoop).
Apply caps to roof rails and bolt together with 5/16"-18 x 7/8" socket head cap screws. Tighten bolts.
Position Mod-Rak JK Stealth in desired location and tighten 55060-00-006 (clamp) around the roof rails.
Step 8
Go back through and be sure all bolts are tight.
Your installation is complete.