FREE 1 to 3-Day Delivery on Orders $119+ Details
Step 1
Be sure to have Congo Pro Front Hoop (55015) and JK-MOD-RAK Low-Pro (55070) installed on JEEP prior to installationof Spreader Bars (55045).
Step 2
Remove end caps from the ends of the extrusion on the JK-MOD-RAK Low-Pro.
Step 3
Slide one 5/16" x 3/4" carriage bolt into the top of the extrusion from the front.
Slide one 5/16" x 3/4" carriage bolt into the top of the extrusion through the middle cutout and slide to the rear.
Slide one 5/16" x 3/4" carriage bolt into the side of the extrusion in the rear.
Step 4
Place end of spreader bar on top of extrusion while aligning carriage bolts previously installed. Bolt spreader bar to extrusion using carriage two carriage bolts, two 5/16" flat washers and two 5/16" NYLOC nuts.
Step 5
Bolt the middle of the spreader bar to the extrusion using one carriage bolt, 5/16"
flat washer and 5/16" NYLOC nut.
Step 6
Place front clamp of Spreader Bars around the A-frame and bolt using twelve 5/16" - 18 x 7/8" socket head cap screws.
Keep clamps loose to allow adjustment.
**The bend in the spreader bars should bend in towards eachother.
Step 7
Repeat on driver side.
Step 8
Go back through and tighten all bolts from previous steps.
Your installation is complete.