Free Shipping on Orders Over $75. Details

Talk to Wrangler Enthusiasts
1-877-870-8556
M-F 8:30A-11P, Sat-Sun 8:30A-9P

How to Install XT Graphics Stereo/GPS Protection Film on your Wrangler

Installation Time

15 minutes

Extreme Terrain
Shop Parts in this Guide

Step 1:

Clean inside of car can aid in eliminating dirt and lint that may be picked up due any static.

Step 2:

Position screen protector on screen starting on one vertical side of the screen.

Step 3:

Once the edge is on slowly arch the screen protector running your finger up and down the screen as you slowly lower it on to the screen. Do not put too much pressure on the screen with you finger.

Step 4:

If it is misaligned after you are done you can gently pull it back and start again

Step 5:

Once you have the decal in its final position, you can then press into place. If there is any air bubbles try to slide the out to the nearest edge, do this before you put any final pressure on the protector. You can peel back a bit if you need to as well.