Excessive Industries Ultimate High Line Front Fenders; 4-Inch Width; Bare Steel (07-18 Jeep Wrangler JK)Find parts that fit my vehicle

Looking for the best high line fender for your Jeep Wrangler JK? Well, you've found them! Our Ultimate High Line Front Fenders are designed to be the best looking, best functioning fenders on the market. Constructed from 1/8th inch P n O steel, and designed to take a beating.

The two-piece design allows for exceptional strength for unmatched fender mounting. We have also added inner braces to the front and rear of the inner fender.

Our inner fender uses all factory mounting points on the outer fender skin. It uses the holes that the factory plastic clips pop into. These holes are drilled out to 29/64 to install 5/16 riv-nuts. The inner fender wraps around the edge of the factory fender opening and attaches to the bottom of the sub frame, as well as our added rear inner brace.

These high line flares raise the fender substantially for increased tire clearance, suspension articulation and steering angle. Available in a 4 inch and 6 inch wide flare. (4 inch shown) it uses all the factory mounting points that have been swapped out to riv-nuts.

Installation is quick and easy thanks to the design of the rear inner brace which serves as a template, showing you exactly where to drill the holes for its placement. This brace ties the outer fender skin to the inner flange of the tub and is part of the system used to strengthen the mounting of the fender flare.

We've also improved the front brace on the factory fender. By removing the factory brace and replacing it with ours, it allows for trimming of the front bottom corner of the fender opening. This also allows you to trim the bottom corner of the grille, making more room for large tires, increasing steering angle and suspension articulation.

All Hardware Included

Made In American

Ships Bare Steel

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov