Free Shipping on Orders Over $75. Details

Talk to Wrangler Enthusiasts
1-877-870-8556
M-F 8:30A-11P, Sat-Sun 8:30A-9P
Win $5,000 For Your Wrangler! Enter daily!

How to Install Dirty Dog 4x4 Rear Seat Netting - Black (07-11 Wrangler JK 4 Door) on your Jeep Wrangler

Installation Time

30 minutes

Extreme Terrain
Shop Parts in this Guide

-Thank you for purchasing a Dirtydog 4x4 netting system. Please read these instructions fully to familiarize yourself with the installation. Set aside 15 minutes for the first time you install your net. Installation is done easiest with the hard top removed and the soft top is open. 

Use the schematic diagram to identify front and back. Start at one of the front corners over the speaker bar. Wrap the long strap around over the front of the speaker/roll bar and bring under and around up the side and feed into the ladderloc.      



Go around to each corner and repeat the same installation method. 

Install the straps on the on the side roll bars. Adjust all the straps according so the net is centered and evenly spaced.      


Install the two straps on the rear roll bar.      


Install the front straps as shown. The straps get fed under the roll bar as shown (next page)      



Adjust and tighten straps as needed to even out the net so it is positioned properly. Your net comes with a 3 year warranty against manufacturing defects. Cuts, abrasions, sun faded items are not covered under the warranty.