How to Install Crown Automotive Rear Seat Cover - Black/Gray (07-10 Wrangler JK 2 Door) on your Jeep Wrangler

Headrest Cover Install

1. Remove the headrests from the seats and slide the covers over them. Put headrests aside for the time being.

Rear Seat Cover Install

1. Unzip the seat back cover and pull it over the seat with the pockets facing the rear of the vehicle. Once the cover is properly adjusted it can now be zipped up.  

2. Pull the flap through the bottom of the seat cover and affix the Velcro from each end of the cover to it. The seat buckle must be fed through this flap on the wide section of the seat.  

3. Adjust as needed to achieve a proper fitment.  

4. With the buckles unclipped and the straps loose, slide the seat bottom covers over the seats. Once properly adjusted, clip the buckles around a secure point on the seat. Tighten the buckles evenly until the covers are snug against the seats.  

5. The headrests can now be re-installed.  

Shoulder Belt Pad Install

1. Open the Velcro strap and wrap around the shoulder belt at the desired area and affix the Velcro.

Washing Instructions:

1. Do not machine wash. Use a mild soapy water solution to remove stains or soil. Do not use an abrasive sponge or rub too hard on the Neoprene as it may damage the material. Let air dry.