Installation Time
(approx) 2 Hours
Difficulty Level:
Light to Moderate mechanical skill required.
Installation Guides
No guide available for this part yet.
FREE 1 to 3-Day Delivery on Orders $149+ Details
Talk to a Wrangler Sales Tech
1-610-990-4559
M-F 8:30A-11P ET, Sat-Sun 8:30A-9P ET
RPM Steering 1-Ton Aluminum Tie Rod and Drag Link Kit with 1.50-Inch I.D. Heavy Duty 6-Bolt Stabilizer Clamp; Factory Location/Under Knuckle (07-18 Jeep Wrangler JK)
Item J251210
$0.00
Our Price
$604.98 kit
Military, Medical & First Responders
Earn $30.25 in XT Cash Rewards. Get Verified
CONFIRM THIS FITS YOUR VEHICLE!
Saved - View your saved items
We're sorry. We couldn't save this product at this time.
or use
Product Information
Features, Description, Q&A, Specs & Installation
Features
- Tie Rod and Drag Link Kit
- Designed for Factory Location / Under Knuckle
- Recommended for Lifts Less than 3-inches
- Stabilizer Must be run in the Stock Location
- Stabilizer Clamp Included
- Bolt-on Installation
- Fits 2007-2018 Jeep Wrangler JK Models
Description
1 Ton Heavy Duty Aluminum Tie Rod and Drag Link Factory Location Kit. The factory JK tie rod is made from a hollow thin-wall tube. The PROBLEM is that most aftermarket units are still made of steel which once bent will stay bent. RPM Steering's tie rod and drag link are made with 1.5" SOLID 7075 aircraft aluminum. 7075 aluminum carries a memory to it. When it is bent, it pops back into place!
1.5" I.D. Heavy Duty 6 Bolt Stabilizer Clamp. RPM Steering clamps are milled and tapped to accept the included 1/2'' grade 8 bolt with washers. The washers provided can be used as spacers to fit your stabilizer. Finished with a durable zinc coat.
PLEASE NOTE:
- 7075 Center section with Limited Lifetime Warranty
- Hexed ends for easy adjustment
- Right and left hand threaded offset 1-ton tie rod ends for one-handed adjustment on toe settings
- Greaseable 1-ton tie rod ends
- Bolt-on steering (No Drilling Required)
1.5" I.D. Heavy Duty 6 Bolt Stabilizer Clamp. RPM Steering clamps are milled and tapped to accept the included 1/2'' grade 8 bolt with washers. The washers provided can be used as spacers to fit your stabilizer. Finished with a durable zinc coat.
- Factory stabilizers may need to be drilled out to accept the 1/2'' bolt
- Not for use with PSC Hydro Assist, we sell a different clamp for this
- For use on 1.5'' diameter rods
PLEASE NOTE:
- Stabilizer must be run in the stock location
- AEV or stock Rubicon wheels require a 1.5" wheel spacer
- 17" wheel with a 4.75" backspacing or less required
- Recommended for less than 3'' lift
- Flip kit recommended if 3'' or higher lift
RPM Steering J251210
CA Residents: 
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Installation & What's in the Box
Installation Info
What's in the Box
- Tie Rod
- Drag Link
- Stabilizer Clamp
Questions & Answers
No questions about this product yet.
Ask the First Question
