How to Install TruShield Wrap Around Net - One Piece on your Wrangler

Lay the net out on a large flat surface with the label at the top right.
When the net is installed, the label will be facing out on the right side of the Jeep.
Loosely connect the buckles (circle 1) of the upper most straps to the highest point on the vertical roll bar on both sides.
Loosely connect the lower most buckles (circle 2) at the lowest point of the roll bar.
Connect the remaining straps and adjust the connections of the side panel and rear panel as necessary so the vertical and horizontal straps are 90 degrees to each other.
With the enclosed Velcro straps and hooks (circle 3), secure the lowest most horizontal strap to the Jeep body to prevent the net from working up.
Note: Roll cages expand and contract with temperature changes. Occasional tightening may be necessary for a day or two and should be done hi the cool of the morning.
Tip: To get the straps extra tight, grab a hold of the strap ends with pliers when pulling.
Tip: To conceal the strap ends, push them back through the buckle and roll them up.