How to Install Barricade Trail Force HD Rear Bumper (87-06 Jeep Wrangler YJ/TJ) on your Jeep Wrangler

Installation Instructions:

1. To install the Barricade Trail Force HD Rear Bumper you must first remove factory rear bumper.

2. Remove rear bumper end caps using T30 Torx bit. There are 5 bolts on each side, 2 on the top side and 3 on the bottom side. Remove the 2 topside bolts on each side first.

3. Remove the 3 bolts on each side of the bottom side of the bumper.

4. Remove 18mm bottom side bolt on the driver and passenger side of the bumper.

5. Remove the 2 back side 18mm bolts on drive and passenger side of the bumper.

6. With the factory bumper removed, install the Barricade Trail Force HD Rear Bumper using the provided 6 - 18mm bolts. Use the original 6 holes for the factory bumper for the new Barricade Rear Bumper, 3 on each side.

7. You now have the Barricade Trail Force HD Rear Bumper installed.

Installation Instructions provided by ExtremeTerrain Customer