How to Install TruShield Rear Overhead Net on your Wrangler

Lay the net out on a flat surface with the label at the top right. When the net is installed, the label will be facing up on the right hand side of the Jeep.
Attach the straps around the roll bar and back to the plastic connectors (see photo). Adjust as needed.
To conceal the strap ends, feed them back through the slot in the plastic connector and roll up.
When used in combination with the One Piece Wraparound Net, the two nets can be attached with the hook & loop fasteners provided.
Note: Roll bar cages and webbing are subject to expansion and contraction with temperature variations. Occasional tightening may be necessary and best done in the morning when cool.
Tip: Use pliers to grip the strap end to pull extra tight.