How to Install a Barricade Matte Black Grille Cover on your 2007-2017 Jeep Wrangler JK

***Before beginning, be sure the grille area is clean and free of any grease, dirt, or dust***

Using a trim removal tool or flat head screwdriver, remove the two clips at the top of the grille as shown.

Using adhesive remover and a plastic squeegee or similar tool, remove the “Jeep” emblem from the top of the grille.

Using the supplied alcohol prep pads, thoroughly wipe down the surface of the grille where the 3M adhesive tape will make contact. Peel the backing from the 3M tape and install the cover over the grille, but do not press down to fully seat the adhesive at this point.

Re-install the clips removed in Step 1 into the top of the grille. Once the clips are re-installed, press down firmly on the grille cover to fully seat the adhesive tape.

If desired, re-apply 3M tape or similar to the back of your “Jeep” emblem and re-install over the grille cover.