How to Install Barricade Trail Force HD Full Width Bumper w/LED Lights on your Wrangler

INCLUDED COMPONENTS

(1) Bumper
(8) 12mm spring washers
(8) 12mm Flat washers
(2) M12 Hex head screws
(2) LED harness wires
(6) M12 Nuts

STEP 1

Remove the plastic cover below the bottom of the Jeep. Using panel clip pliers or a flat screwdriver, remove the 4 plastic fasteners along the bottom front of the plastic cover shown in Fig 1.

STEP 2
With panel clip pliers or a flat screwdriver again, remove 2 plastic fasteners from behind the Plastic Shield Cover
shown in Fig 2.

STEP 3
With a Phillips Screwdriver, Remove the 2 plastic screw clips along the top of the plastic cover shown in Fig 3.

STEP 4

There will be 8 19mm nuts that connects the bumper to the frame, using the 19mm socket & ratchet, remove these 8 nuts (2 on each side of the frame.) shown in Fig 4 & 4A

STEP 5

Once you remove the factory OE bumper, unclip the fog light connectors that connects the fog lights to the bumper and unclip the wire harmesses using a flat screwdriver along the bottom edge of the bumper to completely remove the factory bumper shown in Fig 5.

STEP 6

Once you remove the factory OE bumper, install the new bumper through the OE frame, you will notice that on the bumper there are 3 threaded studs and 1 threaded insert on each side, once you install the bumper, install the factory spacer plates, 12 mm split washers and M12 Nuts on the threaded studs and place the M12 Bolts through the Threaded insert that is on the bumper shown in Fig 6.

STEP 7 (Optional)

Utilizing the supplied LED light harness for a cut/splice free installation. Plug the bumper mounted LED lights into the harness, then run the harness towards the battery. Connect the red wire to the Positive battery terminal, and the black wire to the Negative battery terminal. Secure the relay away from excessive heat. Then run the switch into the vehicle using an existing wiring grommet, secure extra wire out of the way. Locate a suitable mounting location, clean location of any dirt and grease. Remove the double sided tape backing and firmly secure the switch to the dash.

STEP 8 (Optional)

To use the Factory Fog Light Switch (if equipped), trim the supplied harness and splice both driver side plugs together. Splice both passenger side plugs together. Then using butt connectors or T-tap connectors (not included) connect the driver side LED harness to the factory driver side harness, and the passenger side LED harness to the factory passenger side harness. **Note: Use a test light to verify which wire is 12Volt on the factory harness.

LED Harness Wiring Diagram :

Red to 12V

Black to Ground

STEP 9
Once you have everything in place you are finished with installation. Congratulations on your new product