Free Shipping on Orders Over $75. Details

Talk to Wrangler Enthusiasts
M-F 8:30A-11P, Sat-Sun 8:30A-9P
$6,000 Winner!!! Dathon C. from TN Click Here!
Win $5,000 In Store Credit Enter Now

How To Install Barricade Extreme HD Rocker Steps on your 2007-2016 Jeep Wrangler JK 2-Door

Installation Time

30 minutes

Tools Required
  • Socket Wrench
  • 16MM or 5⁄8 Deep-Well Socket
  • Thread lock
Extreme Terrain
Shop Parts in this Guide

Tools Required:

Installation Instructions:

Note: The factory hardware will be used to mount the Steps. 

1. Locate the body mount brackets on the side of the frame. (fig.1) 

Fig. 1

2. Remove the two 16MM nuts on either side of the Bushing Bolt, on both the forward and rear brackets. (fig.2) 

fig. 2

  1. Apply thread lock to the studs.

  2. Lift the Step into position. Place the tongue of the Step mount over the Bushing Bolt washer and onto the studs. (fig.3&4) 

fig. 3

fig. 4

  1. Loosely thread one nut onto each stud. Fully tighten the nuts to 40- ft/lbs., only after all four are in place. 

fig. 5

6. Repeat steps 15 on the other side. 

Installation Instructions Written by ExtremeTerrain Customer Anthony Dombrowski 04/27/2016