How to Install AFE Magnum FORCE Tube Upgrade Kit w/ Pro DRY S Air Filter (12-18 3.6L Wrangler JK) on your Jeep Wrangler

• Please read the entire instruction manual before proceeding.
• Ensure all components listed are present.
• If you are missing any of the components, call customer support at 951-493-7100.
• Ensure you have all necessary tools before proceeding.
• Do not attempt to work on your vehicle when the engine is hot.
• Disconnect the negative battery terminal before proceeding.
• Retain factory parts for future use.

Refer to Figure A for Step 1
Step 1: Remove the engine cover.

Refer to Figure B for Steps 2-5
Step 2: Disconnect the temp sensor wire harness. 1
Step 3: Loosen the hose clamp at the throttle body.
Step 4: Remove the small section of crankcase vent (CCV) hose. It should be pulled off of the aFe tube. 2
Step 5: Remove the aFe intake tube.

Refer to Figure C for Step 6
Step 6: Pull the temp sensor straight up to remove from aFe tube.

Refer to Figure D for Steps 7-8
Step 7: Insert the provided grommet into the new aFe intake tube.
Step 8: Insert the OE temp sensor into the grommet.

Refer to Figure E for Steps 9-13
Step 9: Install the provided couplings and clamps onto the vehicle. The straight coupling (05-00419) goes on the throttle body. The hump coupling (05-00794) goes on the air filter adaptor.
Step 10: Install the intake tube as shown. Align the tube so that the coolant return line runs above the fan shroud.
Step 11: Plug in the temp sensor harness. 4
Step 12: Reconnect the CCV hose to the aFe tube.
Step 13: Snap the coolant line into the clips on the front of the aFe intake tube.

Refer to Figure F for Steps 14-16
Step 14: Install the aFe high performance air filter.
Step 15: Tighten all clamps.
Step 16: Reinstall the engine cover and reconnect battery. Your installation is now complete.
NOTE: Retighten all connections after approximately 100-200 miles.

Place enclosed CARB EO sticker on or near the device on a smooth, clean surface.
EO identification label is required to pass smog inspection.