Front 12-Inch Coil-Over Towers without Bump Cans (07-18 Jeep Wrangler JK)Find parts that fit my vehicle

2007-2018 Front 12'' Coilover Towers JK/JKU Our RPM Steering towers are designed with appropriate outward lean to allow a 12" coilover full range of motion without a need for notching the frame on a JK/JKU. In addition, we run an 8.5" wide base so that the coilover will not rub on the tower when moving front to rear. These 1/4" steel towers are pre-welded and ready for installation. Included with the price is a set of 1/4'' steel weld on lower coilover axle mounts. When set with our recommended shaft show of 4.5'' the vehicle should net approximately 4.5''of overall lift. Pair with our 14'' Rear coilover tower setup for a perfectly dialed in setup with no guess work. PLEASE NOTE: It comes with pre-welded top cap and shock tabs. Ready to weld to the frame. Sold as a pair. Shock tabs are 1/2'' bolt holes. 1.50'' tab spacing on Coilovers Towers. Pair of coilover axle mounts included. ORI's NOT RECOMMENDED with this tower. See Part RPM-3020.

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov