AGM Weld-On Jack Point for Manual or Electric Jacks

Weld these bad boys to your suspension or chassis for a ultra secure way to lift your vehicle with our Jacks. Their diamond shapes allows for a little bit of play to make sliding the jack over the points easier. But prevents the vehicle from falling off the jack. Lock your AGM Jack to the vehicle when you lift with the Weld-On Jack Points.
Weld-on Jack Point sold as single unit or 4 pack.
NOTE: Your vehicle weighs thousands of pounds. If it rolls that is a huge force put on a small area. Do yourself a favor and only lift on flat ground, with the vehicle in park/gear and tires chocked (rocks, large sticks, tools, tires, etc. make great chocks)
NOTE: Each Weld-on Jack points has extra material on the backside to allow you to sand away material to better contour the Weld-on Jack Point to the shape of the suspension or chassis component you are welding it to. Do the following to know how much material is available.
1. Place the Weld-on Jack point into your Jack.
2. Mark (with a sharpie) the Weld-on Jack point material that protrudes out beyond the face of the Jack. This is the material you have to work with when shaping the backside of the Weld-on Jack point to fit your component. And don't forget to allow an additional .125-.250" of distance in this area for your weld bead. If you have questions, please call or email before installing.

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov