Rugged Ridge Heavy Duty Steering Kit with Damper (93-98 Jeep Grand Cherokee ZJ)

Sturdy Reinforcement. Are you looking to upgrade your Jeep with superior steering components that prevent bent tie rods and are built to last? Rugged Ridge brings you the perfect product in the Rugged Ridge Heavy Duty Crossover Steering Conversion Kit. This conversion kit features heavy-duty steel tubes that are 1-1/4-inch thick. These tubes are cold-rolled, pierced, and drawn through dies to produce a 1/4 in. wall thickness.

Built to Perform. This DOM tubing has no seams, or welds that can cause future failure. The tapered rod ends are a sturdy 7/8” in diameter, and a perfect fit for factory stock fittings. This conversion kit will give you 1 ton of extra strength without any modifications required to your steering components.

Superior Quality. This product comes with a damper and features a bolt-on application, therefore, no drilling is required.

Installation. The manufacturer recommends an expert mechanic install this conversion kit. The installation time is approximately 3 hours.

Technical Note. Not recommended for vehicles with over 4 inch of lift. Not compatible with smaller OEM steel wheels or wheels with deep backspacing. Not recommended for vehicles with under 2 inch of suspension lift

Warranty. Rugged Ridge stands behind this conversion kit with a 5-year limited warranty. Any defect found in the materials or workmanship will be covered in full.

Application. The Rugged Ridge Heavy Duty Crossover Steering Conversion Kit fits all 1993-1998 Jeep Grand Cherokee ZJ Models.

Fitment:

• 1993 Jeep Grand Cherokee
• 1994 Jeep Grand Cherokee
• 1995 Jeep Grand Cherokee
• 1996 Jeep Grand Cherokee
• 1997 Jeep Grand Cherokee
• 1998 Jeep Grand Cherokee

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov