Talk to a Wrangler Sales Tech
1-877-870-8556
M-F 8:30A-11P, Sat-Sun 8:30A-9P
Logo Image
$20K Sweeps! 10 Chances to Win! Enter Daily >

How to Install Kargo Master Rocker Walk Side Steps (07-17 Wrangler JK 2 Door) on your Jeep Wrangler

Installation Time

1 hours

Tools Required
  • 3/16" Allen Hex
  • 5/16" Allen Hex
  • M13 Socket and Wrench
  • 1/2" Socket and Wrench

Step 1
• Remove factory rocker guard from JEEP.
• Remove both body mount bolts.


Step 2
• Bolt inner support (56010-22) to the flange where the factory rocker was removed. Bolt through the square holes in the inner support using four 5/16" carriage bolts, four 5/16" washers and four 5/16" NYLOC nuts.

*TIGHTEN BOLTS


Step 3
• Place large step cover (56010-21) on top of previously installed inner support.
• Bolt through the slots in the step cover into inner support using four 5/16" button heads, four 5/16" lock washers and four 5/16" flat washers.

**DO NOT TIGHTEN**


Step 4
• Under the JEEP, reinstall the 2 body mount removed in step 1. Bolt through the slot in the step cover.

**DO NOT TIGHTEN**


Step 5
• Back under the JEEP, bolt support brackets (56000-13) to the step cover using four 5/16" button heads, four 5/16" lock washers and four 5/16" flat washers.

**DO NOT TIGHTEN**


Step 6
• Bolt through previously installed support bracket into the weldnut underneath of JEEP using two M8 bolts, two lock washers and two flat washers.

**DO NOT TIGHTEN**


Step 7
• From the outside of the JEEP, align the gap between the step and the body of the JEEP to your liking.
• Tighten button head bolts from step 3 starting with the far most outside and working towards the middle.
• Once the top bolts are tight, tighten body mount bolts underneath of the JEEP.
• Finally, tighten support bracket bolts from step 5 and 6 to both JEEP and the step.

Step 8
• Bolt 1/2" Button head, 1/2" lock washer and 1/2" flat washer to outside of step.
• Repeat at both ends


Repeat on Passenger side using mirrored parts.

Your installation is now complete