Construction. These bars from Rock Hard 4x4 Parts are made in the USA and constructed from 1 and 3/4 inch by 0.12 inch thick steel. These bars are unpainted, so it is recommended to spray paint or powder coat them before installation to prevent rust. The rear side bar and angle bars total 46.2 lbs.
Protection. This set up protects the passengers in the back of a Jeep in case of a roll over.
Application. These bars are a bolt-on for 1987 - 1991 YJ Wranglers. If your Jeep doesn't have a Rock Hard 4x4 Parts Ultimate Sport Cage, you'll need the angle bar clamp set to install these bars.
Manufacturer Part Number (MPN):
- Rock Hard RH1002-C